Mobius Pro kit build question

[btu44]

Hello,
I am building a Mobius Pro but have misplaced the instructions that came with the kit. I have the online manual but not the addendum.

I would like to know the wing spar placement dimensions inside the wing foam? I remember they were alittle different than the Sport model.

Thanks

[GooneyBird-Landing]

Well, I was hoping to not have to open any of the plastic before I could actually sit down and build this thing so I diodn't do the same thing and start to lose pieces... but here you go. We can't have someone interrupting their build that they can't wait to finish, now can we...??

<reading through instruction booklet... whistling>

Ok, maybe I can't help then. I have the Mobius, not the Pro and I do not see an addendum in my booklet. I only see where it says to measure 1-7/8" back from the leading edge at the wingtip, and 4" back from the leading edge at the root, which your PDF manual already says.

As I read it, I have to ask is that the measurement for the front, center, or rear of the wing spar? Is that what your addendum covered, by chance? I'll keep looking through the kit.

-crash-

[Jimv]

Center of the wing spar. The addendum is a seperate sheet.

[btu44]

Crash,
Thanks for looking. It was a seperate sheet that just covered the diffrences. As I remember the spar placement was at 4 1/2" for the fuse side of the wing. The outboard side I think was 1 1/2" but I'm not sure.

Can someone at Airfoilz please verify these numbers for me. :D

[paulg]

here is the addendum- http://www.airfoilz.com/manuals/Mobius%20Pro%20Assembly.pdf

[btu44]

Got it Paul, Thank you!!!