Connecting aileron servo wires to Rx

[Steve G]

Can you advise exactly what I need to connect the two aileron servos to the receiver. I'm guessing a small Y harness but I'm wondering exactly what you're using and recommending... there's nothing mentioned in the manual about needing one, but I can't think of any other way to connect.
Thanks.

[paulg]

We use a 5ch rec and use to separate channels for ails.

[Gary Hoorn]

Steve,
You can use either a Y harness or two separate channels with a computer radio. As an example with my Futaba channel 6 is slaved to channel 1. That way I can plug each servo into the receiver. Almost all computer radios have this slaving feature. If not simply use a Y harness and place the linkage to the aileron on the end of the servo output arm that gives you the correct motion.
Gary