Forum: Edge 540 & NX

I ordered my Edge with the Mickey Scheme.Are these decals suppose to be precut or do I have to cut them out? I didn't have to do that with the Yak.

I've been looking for a new 3D plane to replace my recently crashed Bipe. Everyone from various forums recommends the airfoilz, but I dont know which...

Just thought I'd share my Edge NX rigged up for night flying. http://www.vimeo.com/13275373 Steve

I am on working on building my 540NX. I am on Page 24, Step 24 of the manual (Manual Version 1.0 07/01/09). The picture shows 2 pieces of tape on...

I am a newbe at building and want to know what size and type motor have folks found optimal on this plane?

Here is something I don't see on another thread anywhere... I assembled the wing of my new Edge today, following the directions carefully. The spar...

Hi all, I just finished my build and after programing the ESC as per instructions, which is confusing because on page 1 it states clearly that...

I need some HELP!! I lost the prop adapter again...while flying!! Not fun...this time I found the prop...still connected to the prop adapter...the...

I occasionally slam my plane into the ground. So far I have slammed my Edge 540 into the ground 4 or 5 time. Although the plane still flies just...

Can anyone recommend a good propsaver?

Just received an email from 3DXHobbies confirming my 540 has been shipped. Sadly, my current Edge 540 is foo-barred :( after a mid air collision...

My Yak takes off like its on a rail without any rudder input. My Edge needs a little rudder to counter the torque on take off The only difference...

So...for my personal planes...I use the barrel hinges from Dubro. Alex, who is building his first Airfoilz...probably doesn't have the patience to...

These questions and comments are not meant to be mean spirited in any way, I thought maybe I'd get some questions answered as well as helping to...

Here is the deal.... I have had a few not so easy landings and block that holds the landing gear in is shot.:( The wall of the block broke out and...

I finally finished my 540. Weather permitting, Saturday morning will be the big day. I am still working on setting up the radio and was wondering...

Well, It was bound to happen. I biffed a landing on my Edge. The fuselage cracked right behind the wing. I repaired the depron with foam safe CA. I...

Last night I made my z-bends and epoxied the 1/32 inch wire into the carbonfiber tubing. Tonight (24 hr later) the epoxy is still gummy and the...

This is my first ARF, I haven’t had any problems building it, but I don't really know what I am doing with the motor, battery, receiver, and ESC. ...