Forum: Yak-54 & NX

Just purchased a Yak 54 NX through my local hobby shop. Questions (so far): 1. Fuselage I received is in two pieces (left and right). Am I correct...

Hi Guys, I live in the UK and are so impressed with the Yak NX me and a pal are getting some sent over. We just cant decide on the motor. We love...

Hi, I will be buying my first foamie from Airfoilz and it will be the new full fuse Yak as I understand that the Yak is best for new pilots. I...

Whats a good motor for the yak? I want something that will have enough power to get out of situations.

I have this on my profile airfoilz yak54, almost 20-20L, I mean very very close. Quite motor, great low throttle, draw is good also. What more...

Ok Im digging the New Yak I have. What a fun plane. I was flying a 10x4.7 but it just ate the battery up so fast. Put a regular 1060 on there and...

i would like to remove my landing gear, for a true 3d foamie look but i can not fly like "woody" and catch it in mid hover i will have to belly land...

i am flying a yak 54 with the turnigy 1050 using a apc 10x7 prop flies great any other good motor combonations for this plane thanks jb.

The kit came with a 28" carbon fiber rod. what is that for? didnt see it in manual. Thanks

On page 26 step 12 of the YAK manual it refers to the "enclosed reference sheet" showing vinal placement. I can't seem to find my sheet...can it be...

Hey all! I'm ready to fly my newly completed Yak, but it doesn't pass the radio range test. When I power up the TX then plug the plane's battery...

....to my first Airfoilz Yak. I was getting ready to head up north for the weekend on Friday around noon so I got up early and went out to the...

And it pulls hard. I'm still going back through all my balancing after a pretty serious crash, but it fly's fine, and was able to take out the right...

Will begin building my Yak tomorrow and would like to use a small tail wheel instead of the wire. Any suggestions for a tail wheel for this...

here is a video of my first attempt at night flight ( with my edge 540) am currently working on my yak54 also lighted but only adds about 6gm of...

Hi Guys: I 'm a new guy on the AIRFOILZ block. I am also new to RC flying. I didn't know didly-squat about RC flying until Nov. 2006. Thats when I...

Just finished my Yak and ready to test. Scorpion 2215-18, APC 10-5E, Phoenix 25, Vislero 1300, HS-55 Servos, Hitec Micro 555 Rx., 19 oz. ready to...

I am looking at the parts packages for the Yak to replace the now well worn wing. I am trying to compare what I get with the Replacement Wing vs...

Hello, I just recieved my Airfoilz Yak today and of course prompty starting building it. Everything was going smoothly until i noticed that my...

I flew my new Yak for the first time this morning, and then a few hours later, and then again and again, I just could'nt stop!!! This thing has to be...